Chicken manure dryer is the main equipment for the harmless and resource recovery of chicken farms (including broiler, layer, and breeder breeding sites), and it is one of the process links of organic fertilizer equipment. The chicken manure tumble dryer is the same as other industrial dryers, which are all cylinders, as short as a few meters, and easily 20 to 30 meters. Matters needing attention in the process of adjusting and installing equipment affect its efficiency and noise control.
Installation and commissioning of the chicken manure dryer:
There are seven main points for attention in the installation and adjustment of the chicken manure organic fertilizer dryer:
1. Draw the baseline: Make the cross line, the elevation line, and the center mark on the base target board to achieve convenient and accurate embedding, and consider that the base will not be covered after installation.
2. Install the base and the tug: level the position of the shim, draw the centerline of the base and the tug, according to the drawing requirements, find the installation position of the base and the tug, level and lay it, first grouting the foundation hole, the concrete reaches a certain strength At the time, tighten the anchor bolts, and then install the dryer cylinder after the review is qualified.
3. Install the cylinder and the rolling ring: first, install the rolling ring on the cylinder, and the concave joints required for fixing should be arranged in a positive and negative staggered configuration, and the thickness of the shim should be adjusted to keep the contact between the rolling ring and the concave joint The corresponding gap should not be the same, and the head of the concave joint bolt and the cylinder should be spot welded.
4. Install the big gear: Before installation, check that there should be no collision marks on the interface of the mating surface, clean the contact surface of the big gear and the cylinder, and then carefully align the two gear halves and tighten the interface bolts, and then install the big gear on the cylinder. Physically. Rotate the cylinder to check the radial runout and lateral swing of the big gear until the calibration is qualified.
5. Install the small gear, reducer, and motor: According to the installed large gear, adjust the meshing parameters of the large and small gears and meet the requirements of the equipment. Fix the position of the small gear and reducer motor.
6. Install the gear cover: make it symmetrical with the edge of the gear.
7. After the six adjustments, second grouting is required. The installation review and debugging work related to grouting are carried out simultaneously to ensure the installation quality of the chicken manure organic fertilizer dryer.
Strictly complying with the above seven-step adjustment items can effectively extend the service life of the chicken manure organic fertilizer dryer, improve the use efficiency, and reduce the failure rate of the tumble dryer. Therefore, strictly refer to the manufacturer’s assembly drawings and basic drawings, assembling, and debugging requirements to standardize the construction, which is an effective measure for the adjustment and installation of the chicken manure tumble dryer. There are many other detailed requirements, which are generally required and emphasized in the parameters and instructions.